Polyurethane seal from Freudenberg-NOK Sealing Technologies replaces PTFE seals in hydraulic piston accumulators - Hawaii News Now - KGMB and KHNL

Polyurethane seal from Freudenberg-NOK Sealing Technologies replaces PTFE seals in hydraulic piston accumulators

Information contained on this page is provided by an independent third-party content provider. WorldNow and this Station make no warranties or representations in connection therewith. If you have any questions or comments about this page please contact pressreleases@worldnow.com.

SOURCE Freudenberg-NOK Sealing Technologies

SIMKO 300 seal ring proves impressive in wind power facilities

PLYMOUTH, Mich., Feb. 7, 2014 /PRNewswire/ -- Hydratech Industries, a leading provider of solutions for wind power facilities and hydraulic systems, is relying on a polyurethane sealing solution from Freudenberg-NOK Sealing Technologies for its new hydraulic accumulator. Test comparisons with other products have shown that Freudenberg-NOK's SIMKO 300 seal ring offers distinct advantages over frequently used polytetrafluorethylene (PTFE) seals with regard to operating life, form stability and sealing characteristics.

The durability of sealing rings in piston accumulators is a crucial parameter for operating life. For this reason, piston accumulators undergo accelerated load tests at the Hydratech test center in Sikeborg, Denmark that simulate 20 years of service life. During the testing process, the behavior of the seals under pressures greater than 200 bar and temperatures ranging between -104 degrees to +140 degrees F is measured – conditions that exceed actual stresses. 

Based on its form stability, extreme hardness and low abrasion, Hydratech now uses the SIMKO 300 from Freudenberg-NOK. The sealing solution "fully meets our expectations and is impressive due to its long service life," said Jimmi Wenderby, Hydratech research and development manager.

Most sealing systems in piston accumulators work with two seals, one for oil and another for gas. This leads to increased wear due to the extreme load, especially in PTFE seals. By contrast, the SIMKO 300 is a single seal (consisting of a seal ring and a pressure ring) and is made of polyurethane. Polyurethane's hardness grade of 98 Shore A corresponds to that of PTFE but is much more robust. Its susceptibility to potential surface damage during installation is also lower. The pressure ring creating the necessary pre-tension is made of an elastomer.  

The SIMKO 300 seal's high form stability, its surface firmness and its long operating life make it especially appealing for use in hydraulic pitch controllers in wind power facilities. They are an important component of the security technology in wind power facilities, as the piston accumulator must not merely function reliably under extreme weather conditions but also withstand the high differential pressures that are also produced. The accumulator must be able to operate leak-free over very long periods of time.

The SIMKO 300 is a cost-effective and extremely reliable solution for use in piston accumulators, and it provides a long service life for the wind power station due to its outstanding sealing qualities.

About Freudenberg-NOK Sealing Technologies

Freudenberg-NOK Sealing Technologies is the Americas joint venture between Freudenberg and Co. in Germany and NOK Corp. in Japan. Freudenberg-NOK is a leading producer – through its Automotive, Merkel, Process Seals and Simrit sales channels – of advanced sealing technologies for a variety of markets including: aerospace; agriculture; appliance; automotive; construction; diesel engine; energy; food and beverage; heavy industry; and pharmaceutical.

Founded in 1989 under the legal name Freudenberg-NOK General Partnership, Freudenberg-NOK is headquartered in Plymouth, Mich. and operates more than 20 facilities across the Americas. For additional information, please visit www.fnst.com.

©2012 PR Newswire. All Rights Reserved.